Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Bedienungsanleitung PDF herunterladen (Seite 17)

Remote Link II Technical Guide

Operator Interface

Troubleshooting Tips

Problems with Prism Software

• Verify that the correct COM port, created by the

USB or serial connection, is selected in the Job Site

Window. The COM port number is found in <Control

Panel>, <System>, <Hardware>, <Device

Managers>, <Ports>.

• Verify that the phone number of the remote job site

was typed correctly.

Troubleshooting

Problems with the USB Connection

• Verify that the RDY LED lights up when you try to

connect to a job remotely in Prism. If it doesn’t light

up, disconnect and reconnect the USB connection.

• Verify that the USB drivers have been installed

properly.

NOTE: WattMaster Controls Technical Support cannot

troubleshoot internal PC and/or Windows

-based

operating system problems.

1 2 ... 12 13 14 15 16 17 18 19 20

Keine Kommentare

Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Bedienungsanleitung Seite 17