Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Bedienungsanleitung PDF herunterladen (Seite 6)

IP MODULE

Technical Guide

CommLink 5 IP Module Installation

Installing the OE415-02 IP Module into the CommLink 5

CommLink 5 with OE415-02 IP Module Installed

LANTRONIX

WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev.A11

Pat. 4972,470 06W21

Made in Taiwan

IP Module Installation Instructions:

First Remove The Enclosure Screws That Hold

The Top And Bottom Of The CommLink

Enclosure Together. Remove The Top Half Of

The Enclosure To Access The Circuit Board And

IP Module Socket.

Insert The IP Module’s Guide Pins Into The

Round Pin Holes On The CommLink Circuit

Board As Shown. When The Pins Are Properly

Aligned, Press Down On The IP Module Firmly

To Seat It Into Its Socket.

After Making Sure The IP Module Is Firmly

Seated, Replace The CommLink Cover And

Secure The Enclosure Halves Back Together

With The Enclosure Screws That Were

Previously Removed.

Follow The Instructions In This Guide For

Installing The IP Module Software And

Configuring The IP Module For Your Control

System.

IP Module (Part Of OE415-02

IP Module Kit). Used When

TCP/IP LAN Or Internet

Communications With The

Control System Is Desired.

Location

Pin - Typ.

Round Pin Hole

IP Module

Socket

LANTRONIX

WiPort NR

00-20-4A-89-6B-EE

WP5001000-01 Rev.A11

Pat. 4972,470 06W21

Made in Taiwan

IP Module

Seated In

Socket

PIC

24VAC

GND

PIC

24VAC

GND

PIC

24VAC

GND

PIC

24VAC

GND

Figure 2: Installing the IP Module into the CommLink 5

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module