Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Bedienungsanleitung PDF herunterladen (Seite 6)

CommLink 5 Technical Guide

Operator Interface

Loop Communication Setting

Setting the CommLink 5 SettingCommunications

CommLink 5 Communications Setting

The Loop Switch Located On The Back Of The

CommLink 5 Housing Must Be Set Correctly For

Your Specific Application In Order For The

CommLink 5 To Function Properly.

The Switch Setting Should Be Set To

“Multiple” In The Following Situation:

You Have A Single CommLink With

MiniLink(s) or MiniLink PD(s) Installed On

Your System.

The CommLink

5 Is Factory Set For Multiple Loop Applications.

Loop

The Loop Switch Setting Should Be Set To

“Single” In The Following Situation:

You Have A Single CommLink Without Any

MiniLinks Or MiniLink PDs Installed On Your

System.

MULTIPLE

HIGH

SINGLE

LOW

BAUDLOOP

R (+)

24V

GND

SHLD

T(-)

SERIAL #

MULTIPLE

SINGLE

LOOP

Switch Set To Multiple

Loop Communications

MULTIPLE

SINGLE

LOOP

Switch Set To Single

Loop Communications

Back of CommLink 5

Figure 2: Setting Loop Communications

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi